Jh-01 Controller Manual

This section handles the high-voltage/high-current connections.

Occasionally, JH-01 refers to a small LCD screen on a cheap electric scooter. jh-01 controller manual

[L] ---> L terminal (JH-01) [N] ---> N terminal (JH-01) [1] ---> Thermocouple (+) Red [2] ---> Thermocouple (-) White [4] ---> Relay Common ---> Heater contactor coil one side [5] ---> Relay NO ---> Other side of contactor coil [6] ---> Alarm common ---> Buzzer (+) [7] ---> Alarm NO ---> Buzzer negative : Wait for the display to time out

: Speed Measuring Magnets (typically 1–30, depending on your motor). L terminal (JH-01) [N] ---&gt

: Wait for the display to time out (3–5 seconds) or long-press the Power and Mode buttons again. 2. Common JH-01 P-Setting Codes

| Address (Hex) | Address (Dec) | Parameter | Data Type | | :--- | :--- | :--- | :--- | | 0x1000 | 4096 | PV (Process Value) | Integer (x10) | | 0x1001 | 4097 | SV (Setpoint) | Integer (x10) | | 0x1002 | 4098 | Output % (0-1000) | Integer | | 0x2000 | 8192 | Alarm status (bitmask) | Integer |