Xk3190-c8 Manual ((better)) Page

The display is ON but stuck on a number, ignoring weight changes.

While this article serves as a comprehensive guide, it does not replace the official (Version 3.0 or later). xk3190-c8 manual

| Error Code | Meaning | Fix | | :--- | :--- | :--- | | | No load cell signal / Sensor disconnected | Check load cell cable for cuts. Check resistance between EXC+ and SIG+ (should be ~350Ω or 700Ω). | | Err 02 | Over-range (Signal too high) | Load cell may be damaged, or mechanical binding exists. Remove weight. | | Err 03 | Under-range (Signal too low) | Load cell wires reversed (SIG+ and SIG- swapped). | | Err 04 | RAM/ROM Failure (Hardware) | Internal board failure. Requires factory repair. | | Err 06 | Calibration weight too small | Use a larger test weight. Must be > 1% of capacity (ideally 10%). | | Err 10 | Zero drift > 10% | Power cycle. If persistent, load cell is drifting. | | Ad Over | A/D converter saturated | The load cell mV signal is exceeding 30mV. Reduce physical load. | The display is ON but stuck on a