Smoke Factory Data 2 Manual //free\\ Access

For those interested in learning more about Smoke Factory Data 2, here are some additional resources:

: Features 5-pin XLR inputs/outputs as standard for integration with lighting consoles. Stand-alone Mode smoke factory data 2 manual

Your physical or PDF manual contains a troubleshooting table. Here is an expanded version based on real user reports. For those interested in learning more about Smoke

| Error Display | Meaning | Solution | | :--- | :--- | :--- | | E-1 | Temperature too low (below 180°C) | Wait for warm-up. If persists, check heater connection. | | E-2 | Temperature too high (overheating) | Turn off for 30 mins. Check airflow and fan. | | E-4 | Fluid empty | Refill tank. Prime the system by running the pump manually. | | E-6 | Pump overrun | Air in the fluid line. Run the pump until fluid flows without air bubbles. | | No display | No power | Check PowerCon lock. Ensure the rear fuse is intact (10A, 250V). | | Error Display | Meaning | Solution |

: Press the Enter button once to start fogging and once again to stop. In stand-alone mode, it will fog until it reaches its temperature limit. Control Options