Kl-003 Manual Pdf |best| -
Adjusting the machine for a larger "depth of stroke" to create deep U-shapes or boxes.
Set the Start Temperature higher than the Stop Temperature . Advanced Parameter Menu (Internal Codes) Adjustment Range HC Heating/Cooling Mode Selection H (Heating) / C (Cooling) SC Temperature Calibration Offset value to match a reference thermometer HE Upper Limit Setpoint Restricts how high the user can set the temperature LE Lower Limit Setpoint Restricts how low the user can set the temperature d Temperature Hysteresis The difference before the relay kicks back in Safety and Installation Tips kl-003 manual pdf
(instead of searching blindly):
Have you found a reliable source for the KL-003 manual PDF? Let other readers know in the comments below (if applicable on your platform). For updates on new revisions, subscribe to our newsletter. Adjusting the machine for a larger "depth of
When I start the service, I get the following error:
/etc/init.d/mylar: 44: [: =d: unexpected operator
Any ideas? Need further info?
init.d/mylar works just fine on mine system. Did you change the init.d/mylar file at all? You can paste lines 40-50 here and I can compare it to my working script if you like.
I should also mention that the servics starts.