Audiosonic Caa-09169 Clock Radio Manual Work Best · Confirmed

Use a 3V Lithium CR2032 button cell for clock backup during power outages. Note that the display will not light up on battery power alone .

| Problem | Solution | |--------|----------| | Display flashing 12:00 | Power was interrupted. Reset time (see Section 2). Replace 9V battery. | | Alarm didn’t go off | Check that alarm icon ( or ) is showing. Volume may be at zero (for radio alarm). | | Radio static / weak signal | Extend power cord fully. Move clock away from phone chargers, computers. | | Buttons unresponsive | Unit might be in “lock” mode? Try holding SNOOZE + POWER for 5 seconds. Also try unplugging for 1 minute. | | Dim display even on high | Internal electrolytic capacitors aging – common in older units. Workaround: use in medium-low light. | | No sound from radio | Check volume dial. Try headphones in AUX jack – if sound works, internal speaker may be loose. | Audiosonic Caa-09169 Clock Radio Manual WORK

Plug the clock radio into a standard 120V AC outlet (US standard). The display should light up, flashing “12:00” to indicate no time is set. Use a 3V Lithium CR2032 button cell for