Charmilles Robofil !full! Jun 2026

| Feature | Charmilles Robofil | Sodick (Linear Motor) | Mitsubishi | | :--- | :--- | :--- | :--- | | | Surface finish & Swiss rigidity | High speed (Linear drives) | Ease of use / Price point | | Threading | Best in class (submerged) | Good (requires dry start) | Very Good | | Wire Usage | Standard | Eco-friendly (less waste) | Standard | | Resale Value | High (Brand loyalty) | Medium | High |

You enable the "Automatic Wire Feed" and "Wire Break Recovery." If the wire breaks at 2:00 AM, the Robofil re-threads, repositions, re-levels the gap, and restarts cutting exactly where it left off. charmilles robofil

| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Poor conductivity / wrong offset | Check workpiece ground. Increase FUSE parameter by 10%. | | Wire breaks in cut | Flushing pressure too high/low | Reduce lower nozzle pressure if top surface is splashing. | | Auto-threading fails | Dirty pinch rollers or worn cutting tube | Clean rollers with alcohol. Replace ceramic cutting tube (every 500 hrs). | | Surface finish is rough | Old dielectric water / worn guides | Check resin color (blue=good, brown=bad). Replace lower guide. | | Taper angle error | Incorrect wire center compensation | Re-run WIRE CALIBRATION cycle for U/V axes. | | Feature | Charmilles Robofil | Sodick (Linear

The series includes several generations, from earlier "F" models to more recent "CC" and "SL" series. Table Size (Typical) Key Features Robofil 240 CC Go to product viewer dialog for this item. 19.7" x 13.8" High precision, automatic wire threading Robofil 310 Go to product viewer dialog for this item. 15.75" x 10" 15.75" Z-axis travel for tall workpieces Robofil 440 CC 29.5" x 21.7" Advanced control for fine surface finishes Robofil 690 CC 41.3" x 31.5" Large capacity and high-speed machining Used Wire Edm Machine for sale on Machineseeker.com | | Wire breaks in cut | Flushing