For a crack that is relatively small (less than 5% of the chord length of the surface):
A "crack" in Quicksurface is essentially a hole or an edge break in the polygonal mesh (the STL or OBJ data imported from a 3D scanner). However, it is not always a visible hole. In many cases, a quicksurface crack is a or a micro-gap that is invisible to the naked eye but mathematically significant. quicksurface crack
: Physical components often develop surface cracks due to fatigue, stress, or impact. To repair or replicate these parts, an accurate digital twin is required. The Challenge For a crack that is relatively small (less
3D scanners operate on line-of-sight technology. Whether using structured light or laser triangulation, the scanner must "see" the geometry. Deep pockets, undercuts, or sharp internal corners often result in "shadows" where the laser cannot reach. The result? The software interpolates the data or simply leaves a gap—a crack. : Physical components often develop surface cracks due