Kenko Kk-613d: User Manual

Depth of a blind hole, recess, or step.

This feature covers the functionality, setup, and user guide for the Kenko KK-613D Digital Car Clock Kenko Kk-613d User Manual

| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | | Dead battery, incorrect polarity, or corrosion. | Replace battery (LR44). Check + side faces up. Clean battery contacts with a pencil eraser. | | Numbers jump erratically | Dirty capacitive scale or low battery. | Gently wipe the stainless steel beam with a clean, dry cloth. Replace battery. | | Incorrect measurement (e.g., 0.5mm off) | Jaws are dirty, or zero wasn't set. | Close jaws, clean them, press ZERO . Then measure again. | | Display shows "E" or "Error" | Movement exceeded sensor limit, or battery voltage is unstable. | Turn unit off, wait 5 seconds, turn on. Replace battery if problem persists. | | Unit won't toggle mm/inch | Debris under button or electronic glitch. | Press button firmly. If stuck, reset by removing battery for 30 seconds. | | Jaw tips are bent | Physical damage (dropping or forcing). | Replace caliper. Bent jaws render the tool inaccurate beyond repair. | Depth of a blind hole, recess, or step

: Press D to advance the numbers for the selected parameter. Save & Exit : Press M to return to the standard display. Alarm and Hourly Chime Check + side faces up