Arduino Sensor Shield V5. 0 Manual -

void setup() Serial.begin(9600); myServo.attach(servoPin); pinMode(trigPin, OUTPUT); pinMode(echoPin, INPUT);

| Symptom | Likely Fix | |---------|-------------| | Servo jitters / not moving | Check power jumper – use external 5V supply. | | Sensor reads wrong values | Ensure 3-pin plug orientation: GND matches shield’s GND. | | Bluetooth not responding | Unplug during code upload; re-plug after. | | Shield blocks USB port on Uno | Use a USB extension cable or right-angle adapter. | | 3.3V sensor damaged | Check if sensor requires 5V or 3.3V – shield outputs both. | arduino sensor shield v5. 0 manual

If you encounter any issues with your Arduino Sensor Shield V5.0, refer to the troubleshooting section below: void setup() Serial

Arduino Uno, Leonardo, Mega 2560 (pins match accordingly). | | Shield blocks USB port on Uno

void loop() // Simple servo sweep for (int angle = 0; angle <= 180; angle++) myServo.write(angle); delay(15);

The Arduino Sensor Shield V5.0 consists of the following components:

installed, all VCC pins are powered by the Arduino's 5V regulator. This is only suitable for low-power sensors. External Power : To drive multiple servos, remove the SEL jumper